Effect of SARS-CoV-2 digital droplet RT-PCR assay sensitivity on COVID-19 wastewater based epidemiology

We developed and implemented a framework for examining how molecular assay sensitivity for a viral RNA genome target affects its utility for wastewater-based epidemiology. We applied this framework to digital droplet RT-PCR measurements of SARS-CoV-2 and Pepper Mild Mottle Virus genes in wastewater. Measurements were made using 10 replicate wells which allowed for high assay sensitivity, and therefore enabled detection of SARS-CoV-2 RNA even when COVID-19 incidence rates were relatively low (~10−5). We then used a computational downsampling approach to determine how using fewer replicate wells to measure the wastewater concentration reduced assay sensitivity and how the resultant reduction affected the ability to detect SARS-CoV-2 RNA at various COVID-19 incidence rates. When percent of positive droplets was between 0.024% and 0.5% (as was the case for SARS-CoV-2 genes during the Delta surge), measurements obtained with 3 or more wells were similar to those obtained using 10. When percent of positive droplets was less than 0.024% (as was the case prior to the Delta surge), then 6 or more wells were needed to obtain similar results as those obtained using 10 wells. When COVID-19 incidence rate is low (~ 10−5), as it was before the Delta surge and SARS-CoV-2 gene concentrations are <104 cp/g, using 6 wells will yield a detectable concentration 90% of the time. Overall, results support an adaptive approach where assay sensitivity is increased by running 6 or more wells during periods of low SARS-CoV-2 gene concentrations, and 3 or more wells during periods of high SARS-CoV-2 gene concentrations.

Operationalizing a routine wastewater monitoring laboratory for SARS-CoV-2

Wastewater-based testing for SARS-CoV-2 is a novel tool for public health monitoring, but additional laboratory capacity is needed to provide routine monitoring at all locations where it has the potential to be useful. Few standardization practices for SARS-CoV-2 wastewater analysis currently exist, and quality assurance/quality control procedures may vary across laboratories. Alongside counterparts at many academic institutions, we built out a laboratory for routine monitoring of wastewater at the University of California, Berkeley. Here, we detail our group's establishment of a wastewater testing laboratory including standard operating procedures, laboratory buildout and workflow, and a quality assurance plan. We present a complete data analysis pipeline and quality scoring framework and discuss the data reporting process. We hope that this information will aid others at research institutions, public health departments, and wastewater agencies in developing programs to support wastewater monitoring for public health decision-making.

Rapid SARS-CoV-2 testing with duplexed recombinase polymerase amplification and a bacteriophage internal control

Without global mass vaccination, COVID-19 will continue to infect and cause serious illness, disproportionately in low- and middle-income countries. Point-of-care and home-based nucleic acid amplification tests (NAATs) are valuable tools to control COVID-19 transmission. Here we present a rapid isothermal NAAT for duplexed detection of SARS-CoV-2 and an MS2 bacteriophage internal control. This assay amplifies RNA in less than 15 minutes, utilizes a low temperature of 39°C, and has fluorescence or visual lateral flow readout. This positions our assay for use in low-cost paper-based nucleic acid diagnostic devices for ultrasensitive and reliable COVID-19 detection in POC or home-based settings. © 2021 MicroTAS 2021 - 25th International Conference on Miniaturized Systems for Chemistry and Life Sciences. All rights reserved.

An open source and convenient method for the wide-spread testing of COVID-19 using deep throat sputum samples.

Importance: The rise of novel, more infectious SARS-CoV-2 variants has made clear the need to rapidly deploy large-scale testing for COVID-19 to protect public health. However, testing remains limited due to shortages of personal protective equipment (PPE), naso- and oropharyngeal swabs, and healthcare workers. Simple test methods are needed to enhance COVID-19 screening. Here, we describe a simple, and inexpensive spit-test for COVID-19 screening called Patient Self-Collection of Sample-CoV2 (PSCS-CoV2). Objective: To evaluate an affordable and convenient test for COVID-19. Methods: The collection method relies on deep throat sputum (DTS) self-collected by the subject without the use of swabs, and was hence termed the Self-Collection of Sample for SARS-CoV-2 (abbreviated PSCS-CoV2). We used a phenol-chloroform extraction method for the viral RNA. We then tested for SARS-CoV-2 using real-time reverse transcription polymerase chain reaction with primers against at least two coding regions of the viral nucleocapsid protein (N1 and N2 or E) of SARS-CoV-2. We evaluted the sensitivity and specificity of our protocol. In addition we assess the limit of detection, and efficacy of our Viral Inactivating Solution. We also evaluated our protocol, and pooling strategy from volunteers on a local college campus. Results: We show that the PSCS-CoV2 method accurately identified 42 confirmed COVID-19 positives, which were confirmed through the nasopharyngeal swabbing method of an FDA approved testing facility. For samples negative for COVID-19, we show that the cycle threshold for N1, N2, and RP are similar between the PSCS-CoV2 and nasopharynx swab collection method (n = 30). We found a sensitivity of 100% (95% Confidence Interval [CI], 92-100) and specifity of 100% (95% CI, 89-100) for our PSCS-CoV2 method. We determined our protocol has a limit of detection of 1/10,000 for DTS from a COVID-19 patient. In addition, we show field data of the PSCS-CoV2 method on a college campus. Ten of the twelve volunteers (N1 < 30) that we tested as positive were subsequently tested positive by an independent laboratory. Finally, we show proof of concept of a pooling strategy to test for COVID-19, and recommend pool sizes of four if the positivity rate is less than 15%. Conclusion and Relevance: We developed a DTS-based protocol for COVID-19 testing with high sensitivity and specificity. This protocol can be used by non-debilitated adults without the assistance of another adult, or by non-debilitated children with the assistance of a parent or guardian. We also discuss pooling strategies based on estimated positivity rates to help conserve resources, time, and increase throughput. The PSCS-CoV2 method can be a key component of community-wide efforts to slow the spread of COVID-19.

An undergraduate laboratory to detect viruses in human DNA samples using qPCR.

The COVID-19 pandemic has necessitated the need to reliably detect the presence of viral genomes in human clinical samples. The most accurate viral tests involve the use of qPCR. Thus, it is important for students to understand the mechanism to detect viral genomes by qPCR including critical qPCR controls and how to properly interpret qPCR data. Herein, we describe a 2-week undergraduate laboratory to detect a viral genome in a human DNA sample. The strategy follows a SARS-CoV-2 qPCR test in numerous ways. Students are provided isolated DNA representing a mock human patient sample, and determine if a viral genome (bacteriophage lambda) is present using qPCR. A battery of control samples and patient pooling strategies are utilized. The laboratory exercise is successful based on high rates of student success in detecting viral genomes, pre-quiz and post-quiz assessments focusing on viral qPCR testing, and positive student comments.

Multicenter Technical Validation of 30 Rapid Antigen Tests for the Detection of SARS-CoV-2 (VALIDATE).

During COVID19 pandemic, SARS-CoV-2 rapid antigen tests (RATs) were marketed with minimal or no performance data. We aimed at closing this gap by determining technical sensitivities and specificities of 30 RATs prior to market release. We developed a standardized technical validation protocol and assessed 30 RATs across four diagnostic laboratories. RATs were tested in parallel using the Standard Q® (SD Biosensor/Roche) assay as internal reference. We used left-over universal transport/optimum media from nasopharyngeal swabs of 200 SARS-CoV-2 PCR-negative and 100 PCR-positive tested patients. Transport media was mixed with assay buffer and applied to RATs according to manufacturer instructions. Sensitivities were determined according to viral loads. Specificity of at least 99% and sensitivity of 95%, 90%, and 80% had to be reached for 107, 106, 105 virus copies/mL, respectively. Sensitivities ranged from 43.5% to 98.6%, 62.3% to 100%, and 66.7% to 100% at 105, 106, 107 copies/mL, respectively. Automated assay readers such as ExDia or LumiraDx showed higher performances. Specificities ranged from 88.8% to 100%. Only 15 of 30 (50%) RATs passed our technical validation. Due to the high failure rate of 50%, mainly caused by lack of sensitivity, we recommend a thorough validation of RATs prior to market release.

A Citywide 'Virus Testing': Chinese Government's Response to Preventing and Controlling the Second Outbreak of SARS-CoV-2.

Containing the spread of SARS-CoV-2 is a daunting challenge globally. China, as well as a handful of other countries, has, for the most part, contained it by implementing strict policies. Wuhan's citywide virus-testing program presents a way forward in preventing and controlling the uncertainty, anxiety, instability and complexity it faces over the outbreak of SARS-CoV-2. Inarguably, the health crisis requires time-tested strategies and tactics for coordinating governments' and social entities' response to the health crisis, with a goal toward having and ensuring sustained effectiveness. Because of a possible recurrence of SARS-CoV-2 in Wuhan, the Prevention and Control Headquarters of Wuhan on COVID-19 launched a massive virus testing of Wuhan's 11 million residents; it was completed within 10 days. In light of this unprecedented mass testing, this study applies the situational crisis communication theory to analyze this massive virus-testing process and the mechanisms involved to contain SARS-CoV-2 in Wuhan. While many countries still have partial lockdowns, the second outbreak in Wuhan was an indication of what awaited all SARS-CoV-2-stricken countries post-lockdowns and after community restrictions had been lifted. Therefore, the recently implemented Wuhan control mechanism (in cities, districts and townships) may become a hortatory guide to other world regions as they contend with and consider appropriate measures to control the spread of SARS-CoV-2 and to ensure public safety.

Evaluation of urine SARS-COV-2 RT-PCR as a predictor of acute kidney injury and disease severity in patients with critical COVID-19.

Coronavirus disease 2019 (COVID-19) is an emerging infectious disease caused by severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2), which began as an outbreak in Wuhan, China and has spread rapidly across the globe. Although most infections are mild, patients with severe and critical COVID-19 infections face deterioration of respiratory function and may also have extrapulmonary manifestations, mostly affecting the kidney, digestive tract, heart, and nervous system. Here, we prospectively evaluated the presence of SARS-CoV-2 genetic material using reverse-transcription polymerase chain reaction in urine samples obtained from patients with COVID-19 receiving critical care. Among 51 included patients, we found higher serum creatinine levels, a longer hospital stay, and more frequent need for dialysis in urine-positive patients. These findings could suggest that, in predisposed patients, a direct viral cytopathic effect may contribute to a more severe disease phenotype.